CT714B Stand Assembly
Goal: Fully assemble a stand for CT714B attenuators.
- Insert rods until they stick out a bit through the bottom.
- Bottom view:
- Add nuts to all four rods on bottom side of plate. Hand tighten.
- Full view:
- Add one spacer to each rod.
- Full view.
- Add the first CT714B.
- Add another set of spacers.
- Full view.
- Repeat steps 4 and 5 until all CT714Bs are stacked.
- Add washers to all rods.
- Add wing nuts to all rods.
- Full view.
- Add caps to all rods.
- Full view.
- The nuts on the bottom can easily come loose during assembly. Tighten again as needed.